This is found in the Electrical Settings dialog. With the release of Revit MEP 2011, another such method has been added. Any method to increase the performance is invaluable, no matter how insignificant it may seem. CM loads them all.Ī New Setting to Increase Performance As we all know, performance is one of the key concerns when working with Revit MEP. I use this when I can’t remember the family type. Type CM to add every single available object type to the type selector. Use your keyboard's arrow keys to nudge selected objects left, right, up and down small distances. Tabbing while hovering over a duct or pipe will highlight portions or the entire run (system). Hold your cursor over an angle wall and tap the space bar to have you light fixture or diffuser align to that wall or go perpendicular to it. ![]() Tap the space bar to rotate Light fixtures 90 degrees before you insert them. ![]() Hit the space bar again to cycle back to the last used size. Use the space bar to inherit duct and pipe sizes from objects you have connected to instead of uses the last used size. I thought I would share some nifty tricks that can help make Revit MEP go down a little easier. Sometimes it's the little things which make all the difference.
0 Comments
Leave a Reply. |